Mud tank in solids control system
as per name there are active tank, trip tank, slug tank, reserve tank, mixing tank, frac tank, water tank, etcetera. We usually call reserve tank, slug tanks, trip tank as the auxiliary tanks system. Please find more information on auxiliary tank system
Reserve mud tank
The reserve tank(s) are for storage of excess drilling fluid, base fluids or premixed drilling fluid for future mixing/additions. It could even be a completely different type of mud system for displacing the existing drilling fluid.
Land drilling rigs do not have reserve tanks in their systems. Extra tanks are rented as needed for their operation. These tanks are typically called fractionalization (frac) tanks.
Marine drilling rigs incorporate reserve or storage tanks in their design. The volume and number of these tanks depend on the space available and the available deck load capabilities of the rig. If more storage volume is required for marine drilling rigs, extra storage tanks can sometimes be installed on deck depending on space and deck load availability. The type of drilling fluid stored in the reserve tanks will dictate whether it needs to be agitated. Since the type of fluids stored will vary, adequate agitation should be available if required.
A slug tank or pit is typically a small 20- to 50-barrel compartment within the suction section. This compartment is isolated from the active system and is available for small volumes of specialized fluid. Some drilling-fluid systems may have more than one of these small compart- ments. They are manifolded to a mixing hopper so that solids and chemicals may be added and are used to create heavier slurry to be displaced partway down the drill pipe before trips. This prevents drilling fluid inside the pipe from splashing on the rig floor during trips. These compartments are also used to mix and spot various pills, or slurries in a well bore. The main pump suction must be manifolded to the slug pit(s).
Proper agitation is needed for this tank because there will be many different types of slurries mixed during drilling operations. Some will be easy to mix, while others will take a lot of energy to mix properly. The addition of a mud gun or guns would be beneficial in mixing various pills as well as keeping solids from settling in the bottom or corners of this tank.
A trip tank should also be a component of the tank system. This mud tank
should have a well-calibrated, liquid-level gauge to measure the volume of drilling fluid entering or leaving the tank. The volume of fluid that replaces the volume of drill string is normally monitored on trips to make certain that formation fluids are not entering the well bore. When one barrel of steel (drill string) is removed from the borehole, one barrel of drilling fluid should replace it to maintain a constant liquid level in the well bore. If the drill string volume is not replaced, the liquid level may drop low enough to permit formation fluid to enter the well bore due to the drop in hydrostatic pressure. This is known as a kick. Fluid may be returned to the trip tank during the trip into the well. The excess fluid from the trip tank should be returned to the active system across the shale shakers
. Large solids can come out of the well and plug the hydrocyclones if this drilling fluid bypasses the shakers.
The addition of trip tanks to drilling rigs significantly reduces the number of induced well kicks. The obsolete or old-system drillers filled the hole with drilling fluid with the rig pumps by counting the mud pump strokes (the volume was calculated for the displacement of the drill pipe pulled). The problem here was that a certain pump efficiency was estimated in these calculations. If the mud pump was not as efficient as estimated, slowly but surely the height of the column of drilling fluid filling the hole decreased. This caused a decrease in hydrostatic head and if formation pressures were greater than the hydrostatic head of the drilling fluid, a kick would occur.
Another common way to induce a kick was to continue filling the hole with the same number of strokes used for the drill pipe even when reaching the heavy-weight drill pipe or drill collars were pulled. Both the heavy-weight drill pipe and the drill collars have more displacement per stand than the drill pipe; therefore a reduction in the height of the column of drilling fluid in the well bore would occur and problems would result.