Cutting dryer maintenance

Cutting dryer designed according to centrifugal separation principle. After processed by it the colloidal-size particles can be removed meet the environmental demand. Today Aipu we will talk about how to maintain cutting dryer regularly.
1. Basket
Basket is not wear part, unless its damage caused unbalance, you do not have to replace it before that.
2. Filter-screen
It is important to always　maintain flite to screen clearance，it is critical to the proper machine performance.
3. It is very important to inspect the condition of the rotor at every screen change. This is necessary as the rotor is the connecting member between the external drive shaft and the basket, and is one of the members which is subjected to normal abrasive wear by the product.
4. Lubrication
Except for the motor bearings, which are grease lubricated, all bearings are oil lubricated. A direct driven gear pump, mounted along the outer base, circulates oil through the gear unit and overflows to the outer external shaft bearings.
The oil should be changed every 1600 hours of operation or every three months, whichever occurs first. To change oil, drain oil from the gear unit and drain pot.
5. Oil filter
Should the filter cartridge become clogged or near so, excessive vacuum will be indicated on the gauge. If, when the machine is warm, 15 inches of Hg. are indicated, the filter cartridge should be changed.
Welcome to Aipu solids control for more information.