Rigsite solids control equipment evaluation tips

Do not exceed the manufacturer's maximum recommended feed rate for a given mud weight or the recommended rotational speed. Have adequate centrifuge capacity to process 5 percent to 15 percent of the rig circulation rate. Reduce feed rates in harder, less mud-making formations. Run the centrifuge constantly on the active system to control mud viscosity. It is better to run the unit continually at lower feed rates while drilling than to feed high volumes to the centrifuge over short time intervals. A fee rate less than the recommended maximum can produce better results.

Above listed items are main equipment used in solids management at rigsite. Please come to Aipu for any further interest or question